- BMS function can be set to (Balance only during charging, Balance During Discharging or Balance all the time)
- BMS can be power by battery pack from 8cells up (power draw from all cells) or by external power supply (15v-60v)
- Alarm and trigger can be set within BMS to control relay to shut off overcharge or over discharge or imbalance in cells.
- BMS can communicate with Chargery charger such as model C10325 (available on my other listing, sold separately)
1. The BMS24T uses advanced
ADC measurement technology, high accuracy, high voltage and high current detection
circuit. The maximum voltage measurements tolerance is within 5mV at up to 24S
2. Support regenerative
braking, during braking operation can charge the batter pack and the discharge
(Wh) will decrease to
response to the braking power.
3. Charge/discharge current
up to 600A. Bigger current can be customized.
4. 1.2A per cell balance
current is very useful for large capacity battery pack, the feature can resume
all cell voltage balance status at the shortest time. Over temperature protection
make sure the system safety during balance.
5. BMS24T calculate and
display the charge and discharge power (Wh), generally the battery rated power
is rated voltage multiply rated battery capacity.
6. TFT LCD screen provides
rich information including current, voltage, power, capacity, battery status,
SOC and temperature and so on.
7. BMS24T features a maximal
safety protection, within the range parameters can be setup, BMS24T will alarm and
cutoff charge or discharge according to users’ setup, out of range of parameters,
and trigged absolute maximum ratings BMS24T will force to cutoff charge or
discharge to prevent the battery from fire.
8. Minimize the power
consumption by draw current from all cells or external power supply.
9. Dual power design, the
unit can be powered by all cells or external power supply.
10. Detect cell count at any
time, and compare with the count detected when switch on first time. If it is
Uniformity, the device will
alarm and cutoff charge or discharge according to users’ setup, the feature can
prevent any cell connection from losing.
11. Sound alarm and LED
alarm will be triggered when any warning events happened, and then wait several
seconds cut off or Don't cut off charge or discharge. The delay time can be
12. Charge relay and
discharge relay are controlled independently.
13. Two temperature sensors
monitor battery temperature on different position.
14. Supports upgrading the
firmware program by USB port.
15. BMS24T provide users the
maximal flexibility, key parameters can be programmed.
16. BMS24T display battery
SOC or called battery gauge similar with car dashboard. Cell count, battery
pack voltage and battery gauge (%) is displayed simultaneously.
17. In case that the battery
pack need not be charged and discharged, Press STOP button enter into sleep
mode to save energy consumption, at this mode, Charge and Discharge is
forbidden, and LCD back light is off.
Press any key to resume
normal work mode.
18. LCD back light ON time
can be programmed to save energy, when it is OFF, press any key to resume "ON”.
1. Cell count error
2. Over charge protection
3. Under voltage protection
4. Over current protection
when charge or discharge
5. Over temperature
6. Over differential cell
7. Over differential battery
8. Under SOC protection
TFT LCD DISPLAY
Beeper 32x13.5mm, 300mm
Warning LED, 300mm
Temperature Sensor, 600mm
Relay Controller wire 600mm
Current Sensor wire, 300mm
Battery Connector XHR-9pin 600mm
USB Data Cable
Communication cable for COM2
300Amps Heavy Duty Shunt 125x27x27mm